Upol Easy 1 Body Filler and Hardener 3lt.

Surface Preparation

Bare Steel S2001 Fast/S2002 Slow Solvent-Based Degreaser P80
Aluminium S2001 Fast/S2002 Slow Solvent-Based Degreaser P180
Galvanised S2001 Fast/S2002 Slow Solvent-Based Degreaser P180
Original Paint S2001 Fast/S2002 Slow Solvent-Based Degreaser P180
GRPS2000 Water-Based Degreaser P180

• EASY 1 LIGHTWEIGHT BODY FILLER FOR DEEP REPAIRS has superb adhesion to all the substrates above.
• For best results, good preparation is essential.
• Clean and degrease removing dirt, oil, grease and wax using cleaning solutions such as U-POL’s SYSTEM 20
• Degreasers.
• Abrade with grit paper as stated above for each respective substrate.
• Re-clean, dry and degrease the abraded substrate ready for application.

10 Degree Celsius 
Mixing ratio (BPO Hardener): 3%
Gel Time: 6 – 7 minutes 
Sandable after: 20 minutes

20 Degree Celsius
Mixing ratio (BPO Hardener): 2%
Gel Time:4 – 6 minutes 
Sandable after: 15 – 20 minutes

30 Degree Celsius
Mixing ratio (BPO Hardener): 1%
Gel Time: 4 – 5 minutes
Sandable after: 15 minutes

Maximum Fill Depth 4 – 7 mm
Infrared Bake: 50 – 80 cm, 80 °C, 5 minutes

• Mix thoroughly on an Onion Board Mixing Palette.
• Follow mix ratio carefully. Do not under or over catalyse.
• Apply with a pressing action to reduce air entrapment.
• Not recommended for applications below 5°C

Sanding
Initial Sanding P80 – P120
Final Sanding P180 – P240

U-POL recommends using Guide Coat Aerosol during the sanding process to identify the high and low spots.

A U-POL Finishing Filler such as DOLPHIN GLAZE can be used to fill imperfections such as pin holes and scratches prior
to painting